Timer - Medion MSH 3002 Handbuch

Timer

The built in timer can administrate up to 12 recordings. Thereby you can choose a fixed
recording date or day of the week for each timer command.
The recordings are programmed in the menu point "Timer" in the main menu. All dates to
the 12 entries can be seen in the overview. The individual entries can be processed using
the OK button. Setting whether a timer should be programmed for a fixed date or a regular
day of the week is done by pressing the LIST button in the date column. If an end time
which is sooner or the same as the start time is entered, the recording will take place on
the following day.
Please take note of the following important instructions for using the timer:
1. The timer is activated by putting the receiver in stand-by mode, if a timer is already
active when the receiver is put in stand-by mode the recording will begin without inter-
ruption.
2. To interrupt an activated timer the STANDBY button should be pressed for a few sec-
onds. A dialogue will appear in which you can choose between deactivating that timer
permanently or temporarily. Press the STANDBY button again to reactivate the timer.
3. In order for the timer to function properly the internal clock must be correct. This can
be checked by looking at the time in the status panel.
The TIMER LED is illuminated permanently when at least one timer is programmed. During
recording the TIMER LED blinks on and off every half a second. If a timer has been pro-
grammed and the receiver has not received correct time information from the TV signal the
TIMER LED blinks quickly to warn you.
Programming transmissions from the EPG
A program can be copied from the daily overview and its detailed view directly into a free
timer by pressing LIST.
46 MSH 3002