Cleaning And Care; Storage And Transport Lock; Disposal - Silvercrest SHBS 600 A1 Bedienungsanleitung

BB*5$B%ERRN 6HLWH 'LHQVWDJ  1RYHPEHU    

7. Cleaning and care

DANGER! Risk of electric
shock!
Unplug the power unit|8 from the wall sock-
et before cleaning the hair and beard trim-
mer|4 and the battery charger|9.
WARNING! Risk of injury!
Always switch the hair and beard trimmer|4
off before cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.
NOTE: clean and oil the device after every
use.
Hair and beard trimmer|
battery charger|
• Wipe the casing of the hair and beard
trimmer and the battery charger with a
damp cloth.
Comb attachments|
out attachment|
• Remove the comb attachment|1 / thin-
ning out attachment|2. Rinse the comb
attachment/thinning out attachment
with water and let it dry before using it
again.
Trimmer attachment|
1. Figure E: remove the trimmer attach-
ment|3 from the hair and beard trim-
mer|4 by pressing it with the thumb
towards the rear.
2. Remove the hair remnants from the at-
tachment using the cleaning brush|12
included in the delivery.
3. Apply a few drops of blade oil|11 to
the cutting edge of the attachment. Us-
ing a soft cloth, wipe off the surplus oil,
if necessary. Only use acid-free oil,
such as e.g. sewing machine oil.
and
4
9
/ thinning
1
2
3
4. Figure F: to attach the attachments,
put the lower flap of the attachment|3
into the slot in the hair and beard trim-
mer|4 and press the upper part of the
attachment against the hair and beard
trimmer until it audibly locks into place
and sits firmly in position.
8. Storage and
transport lock
• For storage ...
... put the hair and beard trimmer|4 in
the battery charger|9 or
... use the included travel case|14.
• If the transport lock is activated, a lock
symbol appears on the display|7
- Press and hold the on/off switch
for approx. 3 seconds, in order to
switch the transport lock on/off.
- Connecting the power unit|8 deacti-
vates the transport lock, which cannot
be activated during mains operation.

9. Disposal

The symbol showing a wheel-
ie bin crossed through indi-
cates that the product
requires separate refuse col-
lection in the European Un-
ion. This applies to the
product and all accessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
.
|6
9
GB