Beampath; Inserting/Exchanging Gobos; Rigging - Futurelight SC-250 Bedienungsanleitung

The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp and focus the light on a flat surface (wall). Center the hot-spot (the brightest part of the
beam) using the 3 adjustment screws "A, B, C". Turn one screw at a time to drag the hot-spot diagonally
across the projected image. If you cannot detect a hot-spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three screws "A, B, C" clockwise ¼-turn at a time until
the light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "A, B, C" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.

Beampath

Inserting/Exchanging gobos

Install the gobos with the device switched off only.
If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Never unscrew the screws of the rotating gobo
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.

Rigging

DANGER!
Unplug from mains before!
CAUTION!
as the ball bearing will otherwise be opened!
22
Distance (m)
Diameter (m)