Cleaning Instructions - Panasonic CU-2E15PBE Bedienungsanleitung

Cleaning instructions

To ensure optimal performance of the unit, cleaning has to be carried out at regular intervals.
Please consult authorised dealer.
• Switch off the power supply before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap (
• Do not use water hotter than 40 °C.
Remove Air Filter
1 1
Press the knobs. Press the knobs.
2 2
Slowly pull Slowly pull
down the down the
intake grille. intake grille.
3 3
Remove the air Remove the air
fi lter from the fi lter from the
tabs and pull it tabs and pull it
downwards. downwards.
For seasonal inspection after extended non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and
air outlet vents:
8
pH 7) or neutral household detergent.
Vacuum, wash and dry.
• lt is recommended to clean the air
fi lter every 6 weeks.
• Do not operate without an air fi lter.
• Wash/rinse the air fi lter gently with
water to avoid damage to the air fi lter
surface.
• Do not dry the part with a hair dryer
or a stove.
• Replace any damaged air fi lters.
COOL: ≥ 8 °C HEAT: ≥ 14 °C
INDOOR UNIT
Wipe the unit gently
with a soft, dry cloth.
Remove Remove
AIR FILTER
For extended non-use
• Activate HEAT mode for 2~3 hours to
remove moisture left in the internal parts
thoroughly to prevent mould growth.
• Turn off the power supply.
• Remove the remote control batteries.
Air Filter Installation
1 1
Insert the air
fi lter to the tabs
of the intake
grille.
2 2
Slowly bring
up the
intake grille.
3 3
Knob
Press the knobs to the
CLOSE side.