Hitachi G 18SH Bedienungsanleitung Seite 8

coloured brown must be connected to the terminal mark-
ed with the letter L or coloured red. Neither core must be
connected to the earth terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not
be applicable to other markets except The United
Kingdom.
Information concerning airborne noise and vibration
The measured values were determined according to
EN50144.
The typical A-weighted sound pressure level:
84 dB (A) (G18SE2, G18SG, G18SH, G18U, G18UA,
G18UB)
88 dB (A) (G23SC2, G23SE, G23SF, G23U, G23UA,
G23UB)
The typical A-weighted sound power level:
101 dB (A) (G23SC2, G23SE, G23SF, G23U, G23UA,
G23UB)
Wear ear protection.
The typical weighted root mean square acceleration
value does not exceed 2.5 m/s
Information for power supply system to be used with
electric tools provided with rated voltage 230 V~
Switching operations of electric apparatus cause voltage
fluctuations.
The operation of electric tools listed below under unfa-
vorable mains conditions can have adverse effects to the
operation of other electric apparatus.
With a mains impedance equal or less than _Z_ Ohms
there will probably be no negative effects.
Usually, the maximum permissible mains impedance will
not be exceeded when the branch to the power outlet is
fed from a junction box with a service capacity of _A_
ampere or higher.
In case of power failure, or when the power plug is pulled
out, immediately return the switch to OFF position. This
prevents an uncontrolled restart.
G18SE2
G18SG
G18SH
G23SC2
G23SE
G23SF
2
.
Z A
0.23 32
0.23 32
0.28 27
0.23 32
0.23 32
0.28 27
English
7