General Directions For Use; Main Components - Zibro R 16 C Gebrauchsanweisung

GENERAL DIRECTIONS FOR USE

Below you will find the main steps to be taken for
using your heater. For more details, please refer to
the MANUAL (pages 41 ff.).
1
Remove all packaging materials (refer to Section A, Fig. A).
2
Fill the removable tank ¾ and wait 30 minutes before you
ignite the heater (refer to Section B, Fig. H).
3
Insert the batteries into the battery holder ¹
(refer to Section A, Fig. F).
4
Check whether the combustion chamber ¿ is fully upright
(refer to Section A, Fig. E).
5
Ignite the heater by turning the knurled wick adjustment
knob · as far to the right as possible and then gently push the
ignition button » (refer to Section C, Fig. J and K).
6
After igniting the heater it will take 10 to 15 minutes before
you can check if the heater burns well (refer to Section D).
7
Switch off the heater (refer to Section E).
•
The first time you ignite your heater it will smell
like 'new' for a short time.
•
Store your fuel in a cool and dark place.
•
Fuel has a limited shelf life. Start every heating
season with new fuel.
•
The right quality of fuel will be assured, when
you use Zibro Plus for your heater.
•
If you change to another brand and/or type of
paraffin oil, you must first finish up all the
remaining fuel in the heater.

MAIN COMPONENTS

³
OFF Button
·
Knurled wick
adjustment knob
»
Ignition
Combustion
chamber
´
Combustion
chamber handle
²
Fuel indicator
¶
Grill
º
Lid for removable
tank
¾
Removable tank
µ
Fuel gauge
removable tank
¸
Ignition coil
¹
Battery holder
4
39