Preparation; Initial Set-Up; Location; Grounding Instructions - Aerfast AC23012 Betriebsanleitung

INITIAL SET-UP:

1. Read safety warnings before setting-up air compressor.

LOCATION:

In order to avoid damaging the air compressor, do not incline the air compressor
transversely or longitudinally more than 10•.
Place the air compressor at least 30 cm away from obstacles that may prevent proper ventilation.
Do not place air compressor in an area:
-where there is evidence of oil or gas leaks.
-where flammable gas vapors or materials may be present.
-where air temperatures fall below 0•C or exceed 40•C .
-where extremely dirty air or water could be drawn into the air compressor.
with this product. If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either flat blade terminal. The wire with insulation
having an outer surface that is green with or without yellow stripes is the
grounding wire.
a grounding type plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and
ordinances.

GROUNDING INSTRUCTIONS:

Do not modify the plug that has been provided, if it does not fit the available outlet, the correct outlet
should be installed by a qualified electrician. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes. If these grounding instructions are not com-
pletely understood or if in doubt as to whether the compressor is properly grounded, have the installation
checked by a qualified electrician.
This product is for use on a nominal 115 or 230 volt circuit, as applicable. A cord with a grounding plug as
shown here shall be used. Make sure that the product is connected to an outlet that matches the plug. No
adapter should be used with this product
(FOR AREA OTHER THAN USA, PLEASE CHECK THE LOCAL CODE.)

PREPARATION

Serious injury or death may occur if electrical sparks from motor
and pressure switch come in contact with flammable vapors,
combustible dust, gases or other combustible materials. When
using the air compressor for spray painting, place the air
compressor as far away I from the work area as possible, using
extra air hoses instead of extension cords.
Improper connection of the equipment-grounding conductor can
result in a risk of shock or electrocution. Check with a qualified
electrician or service personnel if you are in doubt as to whether
the outlet is properly grounded. Do not use any type of adapter
This product must be grounded. If there should be a malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This product is
equipped with a cord having an equipmentgrounding conductor and
CAUTION
WARNING
DANGER
WARNING
9
GB