EUROM 33.395.4 Handbuch Seite 15

INSTALLATION
 Remove all package material and check the appliance, supply cord and the plug for signs of
damage.
 Pay attention to the mounting place for your heater. The appliance has to be mounted on an
incombustible foundation. That foundation has to be vibrationfree, exact vertical and stable
enough for lastingly holding the appliance free of problems. Check or the provided mounting
materials are suitable, strong enough and qualified for the foundation. The material provided
is identified for a brick foundation; for another foundation please ask the specialist for suitable
material.
Mounting at a wall:
 Check before mounting or the minimum safe mounting distances between heater and
environment are strictly followed. The distance between the bottom edge of the appliance
and the floor must be at least 1,8 meter. There must be a distance of at least 0,5 meter
between the appliance and the sidewalls and between appliance and ceiling, roof or other
cover. If the covers consist of flammable material (p.e. wood, plaster, canvas etc.), the
distance has to be at least 1 meter and if you focus the radiator upwards, at least 1,8 meter.
When you install the appliance outside, pay attention that it doesn't catch excessive wind
load.
 Fix the mounting bracket totally
horizontal on the wall with the
four anchor dowels provided.
The short side of the bracket
has to point upwards (see fig.
1).
 See diagram 1 and diagram
'Description' for the materials to
be used (ring, spring washer
and nut).
 Fasten the suspension bracket
to the radiator. To do this, slide
the bracket over the fastening
point of the radiator (see diagram 2), hole with screw thread over hole with screw thread.
Insert the bolt (Philips head) first through the holes without a screw thread, and then through
the holes with a screw thread. Now screw them as tightly as possible. Secure the screw at
the thread end with the locking nut. Now tighten this firmly.
 Slide the radiator with the suspension bracket as far as possible into the wall bracket, in such
a way that the ON/OFF switch is at the bottom. The holes for the fastening screws are now
completely aligned. Insert both of the fastening screws (with black cap) first through the wall
bracket and then through the suspension bracket and screw them together firmly.
Ceiling fastening:
 The TH1800R can be fastened
to the ceiling in the same
manner. Ensure
radiator is suspended
minimum of 2.5 metres above
the ground and at least 1 metre
from side walls and other
that the
a
15