Philips SC2001/01 Bedienungsanleitung Seite 25

Problem
I have switched on the
appliance but I cannot
increase or decrease the
light intensity.
The 'ready to flash' light
does not go on when I
place the appliance on
the skin.
The 'ready to flash' light
does not go on when I
place the attachment on
my skin, but the cooling
fan works.
The 'ready to flash' light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1
when I switch it on.
The appliance produces a
strange smell.
Possible cause Solution
The appliance has To reset the appliance, switch off the appliance and
to be reset. then switch it on again. If you still cannot adjust the
light intensity, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
You have not put Place the appliance in a 90° angle onto the skin in such
the attachment a way that all contact switches touch the skin. Then
with safety ring check if the 'ready to flash' light is on and press the
properly on the flash button.
skin.
If this does not work, place the appliance on a part
of your body where it is easy to establish full skin
contact, for example on your lower arm.Then check
if the 'ready to flash' light works. If the 'ready to flash'
light still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre in
your country, your Philips dealer or a Philips service
centre.
The safety ring is Clean the safety ring carefully. If you are unable to clean
dirty. the safety ring properly, contact the Consumer Care
Centre in your country, your Philips dealer or a Philips
service centre to replace the attachment.
The overheat When the overheat protection has been activated,
protection has the fan still works. Do not switch off the appliance
been activated. and let it cool down for approx. 15 minutes before
you continue to use it. If the 'ready to flash' light still
does not go on when you place the appliance on
the skin, contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service centre.
The appliance To reset the appliance, switch off the appliance and
needs to be reset. switch it on again. If the 'ready to flash' light is green
but the appliance still does not produce a flash when
you press the flash button, contact the Consumer Care
Centre in your country, your Philips dealer or a Philips
service centre.
This is normal. No action required.
The appliance To reset the appliance, switch it off and on again. If the
needs to be reset. appliance still does not show light intensity 1, contact
your Customer Care Centre, your Philips dealer or a
Philips Service Centre.
The attachment Clean the attachment carefully. If you are unable to
and/or the filter clean the attachment properly, contact the Consumer
glass is dirty. Care Centre in your country, your Philips dealer or a
Philips service centre to replace the attachment.
EngliSh
25