TGA641EX(ex).book Page 6 Friday, February 13, 2009 5:35 PM
4
With the handset still on the base unit, wait until a confirmation tone sounds
and w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset according
to the base unit's operating instructions.
• The KX-TG6401/KX-TG6411/KX-TG6451 does not feature an answering
system.
• Answering system features are available only when this handset is registered
to the KX-TG6421/KX-TG6431/KX-TG6461.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.
• Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an
unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has
stopped emitting and contact an authorised service centre.
Installation
• To prevent the risk of fire or electrical shock, do not expose the product to rain or any type
of moisture.
• Do not place or use this product near automatically controlled devices such as automatic
doors and fire alarms. Radio waves emitted from this product may cause such devices to
malfunction resulting in an accident.
CAUTION
Installation and relocation
• The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is
installed near the product and is easily accessible.
Battery
• We recommend using the supplied batteries or additional/replacement batteries noted in
the base unit's operating instructions for replacement battery information. USE ONLY
rechargeable Ni-MH batteries AAA (R03) size.
• Do not mix old and new batteries.
• Do not open or mutilate the batteries. Released electrolyte from the batteries is corrosive
and may cause burns or injury to the eyes or skin. The electrolyte is toxic and may be
harmful if swallowed.
• Exercise care when handling the batteries. Do not allow conductive materials such as
rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the
batteries and/or the conductive material to overheat and cause burns.
6