Remote Operations; Installing The Battery - JVC KS-FX850R Bedienungsanleitung

REMOTE OPERATIONS

This section is ONLY FOR KS-FX850R, KS-FX835R and KS-FX834R.
KS-FX820R can also be remotely controlled as instructed here (with an optionally purchased
remote controller). We recommend that you use remote controller RM-RK31 with your unit.
The followings are the instructions for using RM-RK31.
Before using the remote controller:
• Aim the remote controller directly at the remote sensor
on the main unit. Make sure there is no obstacle in
between.
• Do not expose the remote sensor to strong light (direct
sunlight or artificial lighting).

Installing the battery

When the controllable range or effectiveness of the remote controller decreases, replace
the battery.
(back side)
Lithium coin battery
(product number:
CR2025)
(back side)
WARNING:
• Store the batteries in a place which children cannot reach.
If a child accidentally swallows the battery, immediately consult a doctor.
• Do not recharge, short, disassemble or heat the batteries or dispose of in a fire.
Doing any of these things may cause the batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic materials.
Doing this may cause the batteries to give off heat, crack or start a fire.
• When throwing away or saving the batteries, wrap in tape and insulate; otherwise, , it may cause
the batteries to give off heat, crack or start a fire.
• Do not poke the batteries with tweezers or similar tools.
Doing this may cause the batteries to give off heat, crack or start a fire.
32
1. Remove the battery holder.
1)
2)
2. Place the battery.
3. Return the battery holder.
1) Push out in the direction indicated by the arrow
using a ball point pen or a similar tool.
2) Remove the battery holder.
Slide the battery into the holder with the + side facing
upwards so that the battery is fixed in the holder.
Insert again the battery holder pushing it until you
hear a clicking sound.
Remote sensor