Pioneer PRS-D1200M Bedienungsanleitung Seite 12

Connecting the Unit
Two Amplifier (Ex. Bridge)
2 Ω to 16 Ω
MODE SELECT
switch must be
in SYNC INV
position.
• Only use speakers having an impedance of 2 Ω to 16 Ω. In addition, in the case of connecting multiple
speakers with a bridge, check that the synthetic impedance is at least 2 Ω.
• The setting of the POWER MODE switch varies according to the speaker impedance. Slide the POWER
MODE switch to the HI-CURRENT position if the impedance is from 2 Ω to less than 4 Ω, or slide it to the
NORMAL position if the impedance is from 4 Ω to 16 Ω. The same setting is used for both amplifiers.
• When switching to the SYNC INV mode, the stoper over the MODE SELECT switch must be removed and
you can find SYNC INV switch. Remove the stoper after checking that connections are correct.
Two Amplifier
1 Ω to 8 Ω
1 Ω to 8 Ω
• Use speakers having an impedance from 1 Ω to 8 Ω.
• The setting of the POWER MODE switch varies according to the speaker impedance. See the "Setting the
Unit" section for details. The same setting is used for both amplifiers.
11
MODE SELECT switch must
be in MASTER position.
Connecting speaker wire
(sold separately).
MODE SELECT switch must
be in MASTER position.
MODE SELECT switch
must be in SYNC position.
Connect to a car stereo.
For details, see the
"Connection Diagram".
SYNC OUT
Connecting wire with RCA
pin plugs (sold separately).
SYNC IN
Connect to a car stereo.
For details, see the
"Connection Diagram".
SYNC OUT
Connecting wire with RCA
pin plugs (sold separately).
SYNC IN