Installation; Attaching The Bass Boost Remote Control; Example Of Installation On The Floor Mat Or On The Chassis - Pioneer gm-d8400m Bedienungsanleitung

Installation

Attaching the Bass boost remote
control
Attach with tapping screws (3 mm × 10 mm) at an
easily accessible location such as under the dash-
board.
11
Tapping screw
(3 mm × 10 mm)
Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 18 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm diameter holes at the
point marked, and install the ampli-
fier, either on the carpet or directly
to the chassis.
Tapping screw
(4 mm × 30 mm)
Drill a 2.5 mm diameter hole
Floor mat
or chassis