Troubleshooting - AEG L 87483 FL Handbuch

26 www.aeg.com

12. TROUBLESHOOTING

The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
service centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water.
Problem
The appliance
does not fill with
water.
The appliance
does not drain the
water.
The appliance
door is open or
not closed cor-
rectly.
Possible cause
The water tap is closed.
The water inlet hose is
damaged.
The filters in the water
inlet hose is blocked .
The water tap is blocked
or is furred with lime-
scale.
The connection of the
water inlet hose is not
correct.
The water pressure is
too low.
The water drain hose is
damaged.
The filter of the drain
pump is blocked.
The connection of the
water drain hose is not
correct.
A washing programme
without the drain phase
is set.
The function Rinse &
Hold is on.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
Make sure that the water inlet
hose has no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Clean the water tap.
Make sure that the connection
is correct.
Contact your local water author-
ity.
Make sure that the water drain
hose has no damages.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Make sure that the connection
is correct.
Set the drain programme.
Set the drain programme.
Close the door correctly.