Technical Information For The Fitter; Recommendations; Built-In Installation - Scholtes tse 754 ix Bedienungsanleitung

Read this chapter carefully, as it contains vital information for a safe and secure
installation.

Recommendations

· The appliance must be installed by a qualified technician in compliance with the
instructions provided by the manufacturer.
The latter denies all responsibility for improper installation which may harm persons and
animals and damage property.
· When you have removed the packing, check whether the appliance is intact.
Never leave the packing components (plastic bags, polystyrene foam, nails, etc.) within
the reach of children since these are a source of potential danger.

Built-in installation

This hob can be built into a worktop simply by cutting out the corresponding space. All
support types are suitable: only some plastic materials are unadvised, as heat of up to
approximately 100°C could cause their deformation. Make sure you leave 4 cm of room
between the rear cut-out of the hob and the back of the worktop, to avoid burning the wall
or the backsplash, especially if the latter is laminated.
If the hob is fitted above an oven, in order to avoid any overheating
on the part of the hob's electric components, it is vital that you
leave a space 560 mm wide and 8 mm high between the top
edge of the oven and the bottom of the worktop.
Avoid fitting a dishwasher underneath the hob. If this is
unavoidable, place a watertight separating element between the
two appliances.
68

Technical information for the fitter

Built-in installation type Y (IEC 335-2-6 Norm)
15
40