AEG CTV 4858 Bedienungsanleitung Seite 36

15,4" LCD TV CTV 4858 LCD
FUNCTIONAL PARTS
36
To turn the TV power On
Put the TV set on the correct place, then connect the DC plug of
the AC-DC adaptor to the DC 12V socket at the right side of the TV
set. Connect the adaptor main cord to the wall outlet, then the LED
indicator lamp turns red/blue and the TV set is at Standby/work
Mode. At Standby Mode, if Standby Button is pressed the power
indicator will change to blue. It takes a few seconds before the
picture appears.
To turn the TV power Off
Press the Standby Button to make the TV set in Standby Mode,
then disconnect the power plug from the wall outlet.
Note
If TV is the selected input without signal received and NO
operation is performed for about 5 minutes continuously, the TV
set will enter standby mode. For any inputs other than TV, the TV
set will not enter standby mode automatically without users
instruction. If you are not going to use this TV set for a long time,
switch off the set and disconnect the power plug from the wall
outlet.