PeakTech 1240 Bedienungsanleitung Seite 135

27. Save and Recall the Waveform
This oscilloscope can store 15 waveforms, which can be displayed with the current waveform at the same time.
The stored waveform called out cannot be adjusted.
In order to save the waveform of the CH1 into the address 1, the operation steps should be followed:
1. Saving: Press the H1 button, the Type menu will display at the left of screen, turn the M knob to choose
Wave for Type.
2. Press the H2 button and press F1 button to select CH1 for Source.
3. Press the H3 button and press the F1, turn the M knob to select 1 as object address.
4. Press the H5 button and press F1 button to select Internal.
5. Press the H4 button to save the waveform.
6. Recalling: Press the H3 button, and press the F1, turn the M knob to select 1 as object address. Press
F2 button to set Show as ON. The waveform stored in the address will be shown, the address number
and relevant information will be displayed at the top left of the screen.
Tip:
With the COPY button you can save the currently displayed waveform easily and fast in any user interface on
an externally connected USB storage. The data format is BIN, which can be edited with the enclosed device
software. If you select "External" (external) in the storage menu under Storage (location), you should connect
an USB storage device. To install the USB disk and name of the file, please refer to the following section.
Save the current screen image:
The screen image can only be stored in USB disk, so you should connect a USB disk with the instrument.
1. Install the USB disk: Insert the USB disk into the "1. USB Host port" of "Fig. 3 Right side panel on
page 94". If an icon
The supported format of the USB disk: FAT32 file system, cluster size cannot exceed 4K. Once the USB
disk cannot be recognized, you could format it into the supported format and try again.
Fig. 48 Wave Saving
appears on the top right of the screen, the USB disk is installed successfully.
-134-