Zanussi ZBA 6230 Bedienungsanleitung Seite 41

D022
1. Fit the appliance in the niche by making sure that
it stands against the interior surface of the unit on
the side where the door hinges of the appliances
are fitted. Insert the appliance until the upper strip
butts up against the unit (1) and make sure that
the lower hinge is in line with the surface of the
unit (2).
D132
2. Press in the joint covers between the appliance
and the kitchen furniture.
3. Open the door and push the appliance against the
side of kitchen furniture opposite to that of the
appliance hinges. Fasten the appliance with 4
screws (I) provided in the kit included with the
appliance.
1
2
I
C
D
E
4. Snap vent grill (B) and hinge cover (E) into
position.
Apply blanking covers (C-D) as indicated.
Ha
Hc
PR266
5. Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
ca. 50 mm
ca. 50 mm
6. Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws
supplied.
B
Hb
Hd
90°
90°
41