Audiovox NAV 104 Bedienungsanleitung Seite 231

Button
Switch the map view between a 3D perspective view and a 2D top-down
view.
Adjust the basic zoom and tilt levels to your needs. Three levels are
available.
When selected, the map zooms out to show an overview of the surrounding
area if the next route event (manoeuvre) is far. When you get close to the
event, the normal map view returns.
Switch between daytime and night colour modes or let the software switch
between the two modes automatically a few minutes before sunrise and a
few minutes after sunset.
Select the colour scheme used in daytime mode.
Select the colour scheme used in night mode.
Replace the default position marker to one of the 3D vehicle models. You
can select separate icons for different vehicle types selected for route
planning. Separate icons can be used for car, pedestrian and the other
vehicles.
Show or suppress 3D landmarks, 3D artistic or block representations of
prominent or well-known objects.
Show or suppress 3D city models, 3D artistic or block representation of full
city building data containing actual building size and position on the map.
Show or suppress the 3D elevation of the surrounding terrain.
Turn on or off track log saving, that is, saving the sequence of the locations
your journeys go through.
Select which Places to show on the map while navigating. Too many
Places make the map crowded so it is a good idea too keep as few of them
on the map as possible. For this, you have the possibility to save different
Place visibility sets. You have the following possibilities:
•
•
•
GB
Description
Tap the checkbox to show or hide the Place category.
Tap the name of the Place category to open the list of its
subcategories.
Tap
set or to load a previously saved one. Here you can also revert to
the default visibility settings.
231
to save the current Place visibility