Maintenance; Filter Cleaning - Stanley ST-30L-DH-ME Bedienungsanleitung

NEVER LEAVE DEHUMIDIFIER UNATTENDED WHILE CONNECTED TO A POWER SOURCE
Draining:
Water Tank Draining
– The condensed water will drain into the tank
in the rear of the dehumidifier.
– When the tank is full, the tank full indicator
light will illuminate.
1. Turn off the dehumidifier.
2. Remove and empty the water tank
3. Replace the tank and power the
dehumidifier on.
Figure 6
Continuous Draining
– The dehumidifier can be configured to drain
continuously with a piece of PVC tubing.
NOTE: PVC tubing NOT included with this unit.
1. To install PVC tubing, remove water
tank and plug tubing into drain hole.
2. Replace the water tank in case tubing
becomes dislodged.
3. Be sure to place drain tube at a lower
point than dehumidifier to ensure proper
draining and water flow.
© 2015, Pinnacle Products International Inc

Maintenance

Figure 7

Filter Cleaning:

1. Remove the water tank before removing filter.
2. Remove filter by pulling down on filter tabs.
3. Wash filter with cool water only, DO NOT use
cleaning solvents or alcohol.
4. Air dry filter before replacing and using
dehumidifier.
NOTE: Clean filter once every two weeks of
operation.
Figure 8
. 9