Filling With Salt - Siemens SL60A590 Gebrauchsanweisung

Filling with salt

Note
If the degree of hardness of your
tap water corresponds with value
on the appliance (see chapter
"Adjusting the softening
system"), it is not necessary to fill
the dispenser with salt, as salt is
not used during operation of the
dishwasher. Salt is required for
values
During the washing process the salt is
automatically washed into the softener
and dissolves the calcification.
The calcareous solution is pumped out of
the dishwasher. The softening system is
then reset to standby.
This regeneration sequence does not
function until the salt has dissolved in the
water.
When the appliance is switched on,
low salt is indicated by "Refill salt". (This
display is no longer indicated as soon as
you have set the value for the softening
system to ).
Open the screw cap on the dispenser
.
25
Before switching on the appliance for
the first time, pour approx. 1 litre of
water into the salt dispenser.
Use the enclosed salt filler.
to .
Add salt until the salt dispenser is full
(max. 1.5 kg). When you add salt, water
is displaced and runs away. Salt should
always be refilled immediately before
washing. This ensures that the
overflowing salt solution is immediately
diluted and washed out. Then remove
salt residue from the filling area and
screw down the dispenser without
jamming the threaded plug.
As soon as the salt concentration is
adequately high, the "Refill salt" display
goes out.
If you do not want to wait for the display
to go out before washing, acknowledge
that salt has been added by pressing the
"Acknowledge" button
If you do not want to add any salt at the
moment, you can skip the "Refill salt"
display by pressing the "Acknowledge"
button .
Do not pour detergent into the
container for special salt. This
would destroy the water
softener.
en
.
33