Disposal Of Packaging And Appliance - Pelgrim GVW835 Anleitung

Positioning (see fig. 16)
Note:
You should not allow the hoses to develop
kinks or get flattened during the installation of
the dishwasher in the recess.
Mount the metal plate provided to the
underside of the unit top, moisture could
damage the unit top.
Adjust the dishwasher so that it is level.
Mount the dishwasher to the unit top.
Mount the plinth in place.
Carefully open the dishwasher to check
whether or not the door hits the plinth.
If this is the case, mark the part of the
skirting-board to be removed.
Leave a free space of three millimetres
between the door and the skirting-board so
that the door can open and close freely.
Make the sawn-off piece of skirting-board
waterproof – with paint, for example – and
replace the skirting-board.
What else you should watch out for
Do not make the free space around the
appliance larger than three millimetres. If
there is more free space, there is the risk of
contact with electrical components of the
appliance.
fig. 16
Water outlet
The outlet must be fitted with an odour-
trap.
The drainage hose must hang free inside
the outlet. The outlet may not be sealed off.
The drainage hose should not hang at a
height higher than 80 cm. The minimum
height is 32 cm.
Aquastop
The aquastop system has been built into the
appliance.
The system blocks the water supply in the
event of internal leakage.
Turn off the water tap if this happens and
investigate why the system has blocked the
water supply. Contact the installer or the
service department.
Disposal of packaging and
appliances
The packaging of the appliance is recyclable.
It consists of:
– cardboard
– polyethylene
– CFC free polystyrene (PS rigid foam)
– polypropylene straps around the box
Please dispose of these materials in a
responsible way in accordance with the
regulations of your local authority.
Your local authority will also be able to give
you information about disposing of used
household appliances in a responsible way.