What To Do, When; Possible Cause - Küppersbusch IG 6504.0E Bedienungsanleitung

What to do, when...

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions
given here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- continuous flashing of the start/cancel indicator light,
- a combination of flashing and pauses of the end of programme indicator light (as described in the chart).
Open the door and carry out the following suggested corrective actions.
Fault code / malfunction
- continuous flashing of the
"Start/cancel" indicator light
- 1 flash of the "end of
programme" indicator light
The machine does not fill with
water.
- continuous flashing of the
"Start/cancel" indicator light
- 2 flashes of the "end of
programme" indicator light
The dishwasher will not drain.
- continuous flashing of the
"Start/cancel" indicator light
- 3 flashes of the "end of
programme" indicator light
Once these checks have been carried out; close the door and press the start/cancel button. The programme will continue from the
point at which it was interrupted. If the fault code reappears contact your local Service Force Centre.
For other combinations of fault codes not described in the above chart, please contact your local Service Force Centre.
...there are problems when operating the dishwasher
Malfunction
The programme does not start
There is a whistling noise during
washing

Possible cause

The water tap is blocked or furred with
limescale.
The water tap is turned off.
The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked.
The water inlet hose has not been correctly laid
or it is bent or squashed.
The sink spigot is blocked.
The water drain hose has not been correctly laid
or it is bent or squashed.
Anti-flood device has activated.
Possible cause
The dishwasher door has not been properly
closed.
The main plug is not plugged in.
The fuse has blown in the household fuse box.
The whistling is not a cause for concern.
33
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the threaded hose
fitting.
Check the water inlet hose connection.
Clean out the sink spigot.
Check the water drain hose connection.
Close the water tap and contact your
local Service Force Centre.
Solutions
Close the door.
Insert the mains plug.
Replace the fuse.
Use a different brand of detergent.