Novy Zen 7510 Montage- Und Bedienungsanleitung Seite 20

4.3 Maintenance of the hood
Never use aggressive, abrasive detergents or
sponges.
Do not use an abrasive or scourer.
Maintenance of the bottom side of the cookerhood
Please allow the lights to cool down sufficiently before
cleaning the hood. Use a soft, wet cloth and a mild
detergent to clean the hood.
Maintenance of the Solid Surface material
The housing is made from Solid Surface. Cleaning is
done using a cloth or sponge moistened with a mild
detergent. Then rub dry with a dry, soft cloth to avoid
stains.
4.4 Replacing the lamps
Replacing the cooking lighting
Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
1. Carefully slide down the spotlight holder and then
open the spotlight holder with a tilting movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be re-
placed. Disconnect by means of releasing the
lock, by applying light pressure while at the same
time pulling away.
B. Next, remove the LED to be replaced by making a
gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the
LED light is locked.
C. Connect the power cable.
D. Put back the cover at its place.
Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2700K
(warm white) by default. If the colour is to be changed
to 4000K (neutral white), follow the instruction given
below:
• Open the bottom plate at the bottom of the hood.
• Press with two hands against the side of the inox
lamp holder and carefully pull down simultaneously,
so you get access to the lighting on the inside.
• The wiring has been connected to the LED-lamp
with a connector.
• Disconnect the connector from the LED-lamp and
move the wiring to the other free connection on the
lamp.
• Repeat this for all four LED-lamps.
• Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2700K to 4000K.
Lamps of the ambient lighting
Unscrew the screws on top of the structure. Open the
covers.
Turn the lamp a quarter (1). Push it to the front, until it
comes out of the holder. (2). Pull the lamp to the top.(3)
EN 20