Märklin 29169 Bedienungsanleitung Seite 11

6.3 Connections for the Base Station
Important Information:
!
The connections for the Base Station may
only be made to the switched mode power pack
included with this starter set. Other switched mode
power packs or transformers may not be used!
The Base Station requires the power pack as
a source of power. Therefore, only the power
pack (1) with the cable (2) may be plugged into the
socket on the Base Station (3).

6.4 IR Controller
4 – Lens
5 – Function buttons
6 – Speed controller
7 – Changing direction
8 – Light button
9 – Address selector switch
10 – Battery holder









6.5 Operating the IR Control for the First Time
Before operating this controller for the fi rst time,
2 type AAA batteries must be installed in the con-
troller. Please see the following illustration.
Unscrew the battery holder and lift up the cover.
Install 2 type AAA (micro size) batteries as shown
in the drawing.
1,5 V AAA
1,5 V AAA
Insert or change batteries only in pairs!
!
Pay attention to polarity!
Notes about Batteries and Rechargeable
Batteries
• Non-rechargeable batteries may not be char-
ged up.
• Remove run down batteries from the battery
pack.
11