Trouble Shooting - ZENEC ze 30 mp3 Einbau & Bedienungsanleitung

Trouble shooting

If You Suspect Something Wrong Immediately switch power off. Do not use the unit in abnormal condition, for example without sound, or with
smoke or foul smell can cause fire or electric shock, Immediately stop using it and call the store where you purchased it. Never try to repair the
unit yourself be cause it is dangerous to do so.
General
No power or
no sound
Disc
Disc is inside but
no sound.
Disc sound skips,
tone quality is low.
Sound skips due
to vibration.
16
Car's engine switch is not on.
Turn your car's key to ACC or ON.
Cable is not correctly connected.
Check connection.
Fuse is burnt. Replace fuse.
Check volume or mute on / off.
Disc is upside down.
Place disc in the correct direction,
and the label side up.
Disc is dirty or damaged
Clean disc or change another disc.
Disc is dirty or damaged.
Clean CD or change another CD.
Mounting angle is over 30 o .
Adjust mounting angle to less than 30 .
Instable mounting .
Mount the unit securely with the
mounting parts.
Radio
Much noise in
broadcasts
Preset station
is reset.
Error Display Messages
o
Station is too far, or signals are too weak.
Select other stations of higher signal level.
Battery cable is not correctly connected.
Connect the battery cable to the
terminal that is always under current.
Disc is not CD or contains no MP3 files
Disc upside down
M P3 error, check the disc.
Disc mechanism error
Press button to eject the disc.
In case that the disc cannot be
ejected by pressing button,
press the RESET switch and press
the button again.
If still not ejecting consult your
dealer.
17