Operating Elements - Medion MD 20260 Anleitung

Operating elements

Sensor key Description

You will start the OSD (On Screen Display) with this button. Press this button again if you wish to
leave the OSD.
 +  Power block, when the OSD is not activated
 +  OSD block, when the OSD is not activated
Hold the key combination until the bar displayed has moved from left to right completely, to
activate/de-activate the block. A corresponding message will appear on the screen.

Select a parameter and reduce its value with this button, when the OSD is switched on.
If you are not in the OSD: Direct call-up of the Contrast/Brightness menu.

Select a parameter and increase its value with this button, when the OSD is switched on.
If you are not in the OSD: Direct call-up of the Picture Mode menu.

Confirm the selection of the parameter to be changed with this button.
If you are not in the OSD: choose signal source.

Shows the operational state.

You can switch the TFT monitor on or to the Standby mode with this button.
12
(Ill.: Front operating elements)
Operating elements
    