Maintenance And Repair - BURG WATCHER BURGcam REC 351 Kurzanleitung

Only use the power source specified on the nameplate. Please consult
•
your electrician if you are unsure whether the power supply on-site is
appropriate. Only use the supplied power cables or power adapters or the
specified recommended power supplies.
.3.2 Maintenance and r

1.3.2 Maintenance and repair

Shut off and unplug the equipment from the power socket prior to every
•
cleaning. Only clean the equipment with a slightly dampened cloth.
Do not use harsh cleaners or spray cans. Using harsh solvents such as
thinner or petrol may damage the housing surface.
Immediately shut off the equipment and promptly disconnect it from
•
the operating voltage. The following damages must be handled by an
authorized service centre:
- Damage to the power supply cable
- If a liquid spilled onto the equipment or an object penetrated
the equipment
- If the equipment was exposed to water or another liquid
- If the equipment is not functioning properly despite observing
the instructions in these operating instructions. Only the
controls specified in these operating instructions may be
adjusted. Incorrect settings to the other controls may damage
the equipment.
- If the equipment fell to the floor or the housing was damaged
- If the equipment's performance is substantially lower than the
required performance
Never attempt to maintain the equipment yourself, as this may expose you
•
to hazardous voltages. Maintenance work should always be performed by
qualified personnel only.
Attention:
Opening the appliance will result in loss of warranty.
Do not try to repair the appliance yourself but contact your
local distributor or specialist.
For digital recorders, it is mainly the HDD which subject to natural attrition.
•
HDD attrition may happen after approx. 8,000 to 10,000 hours of
operating time which may lead to malfunctions. We thus recommend to
28 | English
1
BURGcam REC 351