Toshiba MML-AP0074NH-E Installationshandbuch Seite 20

2) How to connect the control wiring
1. Take the control wire out of the cable slot on the rear panel so that it produces about 600 mm form the front.
2. Remove the terminal cover (UP)
3. Remove the LED BASE
4. Insert the control wire fully into the control/Wired remote controller terminal block
tightly with screws.
5. Clamp the control wire with the cable clamp.
6. Pass the banding band through the hole of the mount base.
7. Band the control wire and the remote controller wire in the banding band.
8. Attach the LED base, terminal cover and front panel.
U1 U2
Shield wire
Control wire
LED base
Slot for fi x LED base
Hook for fi x LED base
<How to remove LED base>
18-EN
A B
Remote control wire
<Stripping length of the control wire>
Screw
Control wire
Display base
–18–
, ,
Terminal block for control/wired
remote controller wiring
Remote controller wire
Shield wire for
earth wire
Earth screw for
shield wire
<Connecting control wire and remote controller>
Toshiba 1112750201 (EN)
Installation Manual
, and secure it
Cable
clamp