Blind Hem Foot; Button Sewing Foot - Silvercrest SNMD 33 A1 Bedienungs- Und Sicherheitshinweise

Sewing basics

Blind hem foot

1
2

Button sewing foot

84 GB/ IE
Stitch
D
For hems, curtains, trousers, skirts, etc.
4
Blind hem/ lingerie for firm fabrics.
Fold the fabric as illustrated with the wrong
side uppermost. (1)
Place the fabric under the foot. Turn the
handwheel forwards by hand until the needle
3
swings fully to the left. It should just pierce
the fold of the fabric. If it does not, adjust the
stitch width accordingly. (2)
Adjust the guide (3) by turning the knob (4)
so that the guide just rests against the fold.
Sew slowly, by pressing the foot control
lightly guiding the fabric along the edge of
the guide.
Stitch
B
Install the darning plate. This will cover the
feed dog and the stitch length will be
disabled .
Position the work under the foot. Place the
button on the marked position, lower the
foot, adjust stitch width to "0" and sew a few
securing stitches. Adjust the stitch width
according to the button
handwheel to check that the needle goes
cleanly into the left or right hole of the
button, and sew on the button. Adjust the
stitch width to "0" and sew a few securing
stitches.
If a shank is required, place a darning
needle on top of the button and sew. For
buttons with 4 holes, sew through the front
two holes first, push work forward and then
sew through the back two holes as
described.
Stitch width Stitch length
1~2 3~5
Stitch width Stitch length
0~5 0
. Turn the