Removing/Inserting The Battery; Recharging The Battery; Used Batteries; Operating - FLORABEST FAH 18 C3 Betriebsanleitung

tery several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
battery
1. To remove the battery (9) from the
appliance, press the release but-
ton (10) on the battery and pull
out the battery.
2. To insert the battery (9), place it
on the guide track (14) and push
it back into the appliance. It will
audibly snap in.

Recharging the battery

Recharge the battery when the last
charge state indicator LED (
changes from green to red.
When starting to charge and while
charging, the control indicator
( 12a) of the battery charger (12)
lights up red.
When charging is over, the control
indicator changes to green.
1. Remove the battery (9) from the
appliance, as necessary.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger (12). It will audibly snap
3. Plug the battery charger (12) into
4. When the battery is fully re-
5. Press the release button (

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Operating

Wear suitable clothing and
work gloves when working
with the equipment.
Ensure that the equipment is
11)
functional before each use.
The On/Off switch and the
safety switch must not be
held closed. They must switch
off the motor when on is re-
leased. Should a switch be
damaged, stop working with
the equipment. Ensure that the
mains voltage value matches
the label on the equipment.
Reduce the risk of injuries and
accidents by wearing personal
protection equipment and
ensuring that the unit is fully
functional.
in.
a mains outlet.
charged unplug the battery charg-
er (12) from the mains.
the battery (9) and pull the battery
out of the battery charger (12).
GB IE
10) on
13