Controls And Indicators; Control Panel And Indicator Lights - Candy GO DC 38T Anleitung

40005176Eng.qxd 18/07/2007 11:01 Page 11

Controls and indicators

FILTER CARE
COUNTDOWN DISPLAY
INDICATOR
EMPTY START ON/OFF PROGRAMME
ACRYLICS/ START
WATER DELAY BUTTON SELECTOR
SYNTHETICS BUTTON
INDICATOR BUTTON
BUTTON

Control panel and indicator lights

Programme Selector – Select the required programme
On/Off button and indicator – Press to switch on, the indicator will light
Start – Press Start to commence the selected drying programme. Press for 5 seconds to
cancel/reset the programme
Acrylics/Synthetics button – Press to reduce the heat level for delicate items, the
indicator above the button will light up. To change the heat setting the programme
must be reset
Low Heat – Indicator light ON High Heat – Indicator light OFF
Empty Water indicator – lights when the water container is full
Filter Care indicator – lights when the filter needs cleaning
Start Delay button – Allows the user to delay the start of the drying cycle (see
details of operation page 16)
Display
START – When the dryer is switched On the START indicator will flash, when the
programme starts the START indicator will light up
60' – Indicator lights when there is less than 60 minutes left until completion of the
programme
15' - Indicator lights when there is less than 15 minutes left until completion of the
programme. At this stage of the drying cycle the machine enters the Cool Down phase
STOP - Indicator lights when the programme is finished.
6h - 6 hour start delay (light flashes when in operation)
9h - 9 hour start delay (light flashes when in operation)
11