Internal Cleaning; Troubleshooting - AEG FAVORIT 99019 M0P Benutzerinformation

36 www.aeg.com
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.

9.4 Internal cleaning

If you regularly use short duration pro-
grammes, these can leave deposits of

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
Display
Attention: no intake of water possible.
Please ensure the tap is not closed or
blocked.
Attention: water is not draining. Please
ensure the drain tube is not attached
wrongly.
Attention: The antiflood system has
been activated.
WARNING!
Deactivate the appliance before
you do the checks.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
grease and limescale inside the appli-
ance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
With some problems the display
shows a message.
Problem
The appliance does not fill with wa-
ter.
The appliance does not drain the wa-
ter.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
Make sure that the appliance door is closed.
The display shows a message if the door is
open.
Press the start touchpad.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.