myaudioart MA3 Bedienungsanleitung Seite 43

Establishing a Bluetooth
Before the initial data transmission between two Bluetooth
the devices must be connected to each other. This pairing (coupling) involves storing
the connection keys for data transmission. After that, each playback device or smart
phone will usually be connected automatically as soon as it is close enough and its
Bluetooth is activated.
®
Refer to the manual of the playback device or smart phone to set up Bluetooth
This process may differ depending on the device.
– Activate Bluetooth
Bluetooth devices.
®
– Press the Bluetooth
or keep the SOURCE button on the system pressed for 3 seconds. The LED
BLUETOOTH on the system alternates between red and green.
– Choose MA 3 as soon as it is detected and displayed on the screen of the playback
device or smart phone.
– Press the Bluetooth
or press the SOURCE button on the system.
– Press play on your playback device.
Choosing the audio source
If several audio sources are connected to the system via radio or cable, you can switch
between the audio sources and choose the desired source.
– Press the button for either Bluetooth
remote control to choose the corresponding audio source
or
– press the SOURCE button on the system.
User Manual
on the playback device and start scanning for available
®
pairing button on the remote control (see page 42)
®
pairing button on the remote control (see page 42)
®
, or jack connection (see page 42) on the
®
connection
®
devices can take place,
®
.
®
43