Rear Panel Controls - Tivoli Audio 10+ Bedienungsanleitung

English
Guide to Features (Rear Panel):
10
11
1. 12VDC/1000mA: This input is for use with an optional 1A fused, 12VDC adapter. The adapter
must be 5.5mm/2.1mm center positive.
2. EXTERNAL ANTENNA: An external telescoping antenna is affixed to this input and is not
intended to be detached. Adjust for best reception. For more, see the section marked "Digital
Radio/FM Reception".
3. HEADPHONE OUT: Connect a headset (not included) to this variable stereo output for private
listening. The headset will mute the primary speaker. The headset's volume is adjusted using
the control wheel or the remote control. The remote's "Mono" button also affects this output.
This stereo out-put accepts a 3.5mm stereo male mini connector. Avoid using headphones
at high volume levels to prevent possible hearing damage.
4. PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall the
station associated with that specific preset. In FM mode, the preset number will be indicated
on the display. There are 5 presets for each band.
5. R-SPR: Connect the male RCA cable from the optional Tivoli Audio Model 10 Speaker to
this female RCA output. Make sure the Stereo/Mono setting is set to Stereo by pressing the
Mono button on the remote control and be sure the display shows "ST" for stereo and not
"M" for mono.
6. SUB OUT: Connect the audio cable from the optional Tivoli Audio Model Subwoofer (or other
compatible subwoofer) to this output. This jack accepts a 3.5mm stereo male mini connector.
7. REC OUT: Connect a cassette deck's audio input (or other recording device) to this fixed level
stereo output to record the audio. The primary speaker will not be muted when using this
output. This jack accepts a 3.5mm stereo male mini connector.
8
3
2
5
1
4
8
9
7
6