Solution Suggestions For Problems - Blomberg TKF 7330 Bedienungsanleitung

7

Solution suggestions for problems

Problem Cause
Drying process
Cover filter and filter drawer
takes too much
might have not been cleaned.
time.
* Cover filter and filter drawer
Laundry come
might have not been cleaned.
out wet at the
* Excessive laundry might have
end of drying.
been loaded in.
* It might have not been
Machine does plugged in.
not switch on * The loading door may be ajar.
or the program * Program might have not been
does not start. set or the "Start/Pause/Cancel"
Machine is not button might have not been
activated when pressed.
set. * "Childproof lock" might have
been activated.
Program has
been interrupted * The loading door may be ajar.
without any * Electricity may be cut off.
cause.
Laundry has
* A program suitable for the
shrunk, become
laundry type might have not
felted or
been used.
deteriorated.
Drum lightning
does not come * The machine might have not
on. been started by using the On/
(for models Off button.
equipped with a * Bulb may have blown.
lamp)
* The 2-hour anti creasing
"Final / Anti-
program to prevent laundry
creasing" light
from creasing might have been
flashes.
activated.
"Final / Anti-
creasing" light * Program has come to an end.
is on.
* A heat sensor failure has
The "Drying" light
occurred. Machine ends the
flashes.
program without heating.
Also, for products equipped with a "Condenser" and a "Heat pump"
"Tank full" * Water may be full.
warning light is * Anti-creasing program might
on. be running.
"Filter cleaning" * Filter might have not been
light is on. cleaned.
"Condenser
* Filter drawer/Condenser might
cleaning" light
have not been cleaned.
is on.
A
Call an authorized service if the problem persists.
Explanation / Suggestion
* Clean the cover filter and Filter drawer.
* Clean the cover filter and Filter drawer.
* Do not overload the machine.
* Make sure that the machine is plugged in.
* Make sure that the loading door is properly
closed.
* Make sure that the program has been set and it
is not in "Stop" mode.
* Deactivate the childproof lock.
* Make sure that the loading door is properly
closed.
* Press the "Start/Pause/Cancel" button to start
the program.
* Dry only the laundry which is suitable for drying
in your machine after checking the labels on your
clothes.
* Select a program with suitable temperature for
the laundry type to dry your clothes.
* Make sure that the machine is On.
* Call the authorized service to replace the bulb.
* Turn off the machine and take out the laundry.
* Turn off the machine and take out the laundry.
* Turn off the machine and take out the laundry.
Call your authorized service.
* Drain the water in the water tank.
* Clean the cover filter.
* Clean the filters in the condenser/filter drawer
under the kick plate.
20 - EN