Operating The Appliance - VINCENT CD-S4 Bedienungsanleitung

Many devices which can be controlled by a switching signal (not preamplifiers or integrated
amplifiers), have two terminals which do not differentiate between input and output. In this case
either of the two can be selected. Even some devices that transmit the switch signal (preamplifiers and
integrated preamplifiers) lack this marking. In this case it may be assumed that they both are signal
outputs.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected! All
receiving devices must not be connected to more than one preamplifier or integrated amplifier (direct-
ly or indirectly)!
If a "POWER CONTROL" cable is connected to the back of the CD-S4 and the 12V switching signal
is given, the main amplifier can no longer be switched off with the "POWER" button. If the power con-
trol function is not desired, the switch signal cables must therefore be removed!
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and frequency
can be read on the back of the device beside the socket for the mains. If the electricity supply is appropriate,
push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the device
(14). Connect the other end of the mains cable to a mains socket.
Operation
Switch on and off
Change the level of the
analogue audio output
(10) at the rear panel
Helligkeit der Anzeige
an der Gerätefront

OPERATING THE APPLIANCE

BASIC FUNCTIONS AND SETTINGS
Button(s) Description
The device is switched on and off using this button at the front panel. When
switched off the device is internally NOT separated from the AC power and
POWER (1) reacts to a "POWER CONTROL" (12) switching signal. As a precaution,
before switching on, the volume setting of your system's preamplifier should
be reduced.
This function may only be activated with the remote control and only during
playback. This control is to allow the adaptation of the player to the system
(mainly the amplifier) and it must not be used to change the volume of the CD
player in daily use. It is sufficient for almost all amplifiers/receivers/preamplifiers
VOL + (31)
to put the setting to the maximum and to leave it there. A different value is only
VOL – (32)
used if the CD player is much louder compared with the other sources at the
amplifier/receiver or it is distorted (clipping). Hold down the "VOL+" button to
raise the output level. Use the "VOL-" to reduce it. The two-figure value of the
volume appears in the display (3). The maximum signal level is reached with a
setting of 26 and the minimum is at 00.
This function can only be operated using the associated front panel button.
DIMMER
When repeatedly pressed, the display (3) brightness is periodically reduced
(15)
(1x), switched off (2x) and restored to the original, maximum brightness (3x).
Vincent
35