Sorter - Canon imagePRESS-C1 Serie Servicehandbuch

16.3.5 SORTER

Adresse Controller
P001 STACKER
P002 STACKER
P003 STACKER
P004 STACKER
P005 STACKER
928
Bit Name
0 Inlet feed motor phase A signal
1 Inlet feed motor phase B signal
2 Inlet feed motor phase A* signal
3 Inlet feed motor B* signal
4 Escape feed motor phase A signal
5 Escape feed motor phase B signal
6 Escape feed motor phase A* signal
7 Escape feed motor phase B* signal
0 Punch feed motor phase A signal
1 Punch feed motor phase B signal
2 Punch feed motor phase A* signal
3 Punch feed motor phase B* signal
4 Tray motor CLK signal
5 Swing locking motor current switch IO
6 Swing locking motor phase A signal
7 Swing locking motor phase B signal
0 TxD for external source
1 TxD for write
2 RxD for external
3 RxD for write
4 Punch connection detection
5 OUT for punch communication
6-7 Nicht verwendet
0 Escape feed motor CLK(IRQ0*)
1 Trailing edge detection sensor (This
mode is used at the time of the punch
unit installation.)
2 Saddle connection detection
3 Upper tray FG(IRQ3*)
4 Swing lock HP sensor
5 Swing height detection sensor
6 Front cover open/close sensor
7 Gear change HP sensor
0 TxD for punch communication
1 RxD for punch communication
2 IN for punch dommunication (IRQ2*)
3-7 Nicht verwendet
COPIER>I/O>SORTER
Bemerkungen
-
-
-
-
-
-
-
-
-
-
-
-
-
0: Ein
-
-
-
-
-
-
0: angeschlossen
0: Ein
-
-
-
0: angeschlossen
-
1: HP
1: HP
0: offen
-
-
-
0: Ein
-