Description Of The Device; Features; Starting Operation; Rigging - EuroLite BW-100 Bedienungsanleitung

DESCRIPTION OF THE DEVICE

Features

Bubble machine
A rotating wheel with rings takes up the bubble fluid • A ventilator distributes the generated bubbles in the
whole room • Very low power consumption • Filling up with bubble fluid without any problems • Low fluid
consumption • Hanging or standing installation possible • Countless application possibilities for fashion
shows, in discos, in carnival etc. • Ready for connection with power plug • Simply fill in fluid - ready!

STARTING OPERATION

Install the device on a plane surface.
The liquid tank of the device needs to be filled with bubble liquid before starting up operation and always
disconnected from the mains as fluid could be spilled.
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.

Rigging

Install the device out of the public area. Please consider that liquid may be spilt during operation around the
device. The resulting slippery surface can cause accidents.
Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is constructed for standing installation only. If the device is to be installed overhead, the following
safety instructions are binding:
Please consider the
installation! The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.

DANGER TO LIFE!

EN 60335-1:1996 a nd the respective national norms during the
11/14 00092994.DOC, Version 1.0