basic_e_d4209_7.fm Page 11 Tuesday, February 3, 2004 3:02 PM
INSERTING AND REMOVING THE
BATTERY AND CARD
1
Make sure the camera is turned off.
• The power switch is set to OFF.
• The monitor is off.
• The viewfinder is off.
• The lens is not extended.
2
Slide the battery compartment/card
cover in the direction of A, then lift
in the direction of B.
• Use the ball of your finger to slide the cover.
Do not use your fingernail as this could
result in injury.
3
Loading the battery
Align the battery as shown and
insert it into the battery
compartment until the battery is
locked in position with the battery
lock knob.
Removing the battery
Slide the knob in the direction of the
arrow. When the battery is ejected,
pull it out of the battery
compartment.
Low battery warning
The amount of power consumed varies considerably depending on the
operations performed on the digital camera. If you use an exhausted
battery, the camera may turn off without displaying the battery level
warning .
B
A
Battery lock knob
Battery lock knob
En 11
En