Charge Battery Pack; Ready To Start - Carson Space Taxi Betriebsanleitung

cHarge battery pack

the Space taxi is equipped with a LiPo bat-
tery
3.7 V 1-cell LiPo battery.
1. The supplied LiPo battery is stored in the body of the Space Taxi.
2. Connect the battery to the connector of the USB charger. The
indicator on the USB plug lights up and goes out again once the
charging is completed.
Do not leave the copter or the charger unattended during the
charging process and always disconnect the battery from the
charger after completion! While charging, place the battery and
charger on a fireproof base!

reaDy to Start

Now you can take off! But before it is important, that you read the complete manual.
1
Now use the ON/OFF switch to switch on the transmitter.
3
Now move the throttle lever completely up and then all the way
back down. The Space Taxi is now ready to start.
2
Open the battery case and connect the battery with the correct
polarity. Then, close the battery case and switch on the Space Taxi
using the ON/OFF switch.
29 // GB