Interconnection Example - Hifonics TRX5005 DSP Benutzerhandbuch

5-channel-mode: 2 x Stereo-System (Front & Rear) + 1 x Subwoofer
Subwoofer
1 – 8 Ohms
Loudspeaker Loudspeaker
L & R, front
each 2 – 8 Ohms each 2 – 8 Ohms
INTERCONNECTION
• Connect the RCA lineouts of the head unit with the RCA jacks LINE IN and SUB IN of the amplifier with appropriate high-value
RCA cables. If your head unit is equipped with a separate subwoofer output use this for the SUB IN inputs.
• Connect the front and rear speakers with the SPEAKER OUTPUT + A - and + B - and + C - and + D - as well as the subwoofer with
+ SUB OUT - by using appropriate high-value cables.
Ensure that the total impedance load on each channel pair A/B and C/D is not lower than 2 ohms (bridged 4 Ohms) and on the sub-
woofer channel SUB OUT not lower than 1 ohm.
REMOTE CONTROLLER
Refer to page 7.
DSP-SOFTWARE SETTINGS
Now connect the DSP amplifier via the included USB cable to the computer on which you installed the DSP software before.
Important: Until you have made all basic settings, turn down the volume control of the head unit all the way left to the lowest setting to
avoid damage to the sound system.
30
FUNCTIONAL INSTRUCTIONS

INTERCONNECTION EXAMPLE

L & R, rear
Connect the USB port to the Com-
puter with the enclosed USB cable
Connect the stereo RCA output (FL/FR, RL/RR and SUB OUT) of
the head unit with FL/FR, RL/RR and SUB IN of the amplifier.
STARTING THE PROGRAM
Turn on the head unit (radio) and thus the DSP amplifier. Start the DSP
software. Please also refer to the information on page 8 and 9.
CONFIGURATION OF INPUT CHANNELS
1. Chose under INPUT MODE the setting 6CH.
2. Chose under OUTPUT MODE the setting 2.
Note: If you do not operate an additional amplifier on the audio output
LINE OUT E/F, no adjustments on channel pair E / F are required.
Connect the Remote Controller
with the enclosed cable