Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Addressing the Projector
Set the dipswitch 10 to OFF. At least 1 dipswitch (from 1 – 9) must be set on ON.
Dipswitches 1 – 9 set the DMX addresses.
Addressing
Each device occupies 6 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Controlling:
After having addressed all LED PAR-56 RGB Spots, you may now start operating these via your lighting
controller.
21/42
00023798.DOC, Version 2.2
Werbung
Inhaltsverzeichnis
