General Safety Instructions - Beamz LS-3DG Handbuch

LASER SAFETY LABEL REPRODUCTIONS
LASER EXPOSURE WARNING
LASER LIGHT AVOID DIRECT EYE EXPOSURE

GENERAL SAFETY INSTRUCTIONS

Every person involved with installation and maintenance of this device have to:
Be qualified
Follow the instructions of this manual
CAUTION! Be careful with your operations. With a high voltage you can suffer a
dangerous electric shock when touching the wires!
This device has left out premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe operation, it
is necessary for the user to follow the safety instructions and warning notes written in this manual.
Important!
The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any
unauthorized modification to the device.
Please consider that damages caused by manual modifications to the devise are not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections with the mains with
particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Always plug in the power plug least. Make sure that the power-switch is set to off-position before you connect the device to the
mains. The power-plug has to be accessed after installing the device.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the power-cord from time
to time.
Always disconnect from the mains, when the devise is not in use or before cleaning it. Only handle the power-cord by the plug.
Never pull out the plug by tugging the power-cord.
It is essential to connect the yellow/green conductor to earth.
The electric connection, repairs and servicing must be carried out by a qualified employee.
Do not switch the fixture on and off in short intervals as this would reduce the laser diode life.
Caution – Class 3B LASER RADIATION, WHEN OPEN, AVOID EXPOSURE TO BEAM
LASER RADIOATION AVOID EXPOSURE TO BEAM CLASS 3B LASER PRODUCT.
The label indicates the laser beam output aperture.