Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different
Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned
to. If e.g. a Slave unit is set to „Slave 1" in the menu „Set to Slave", the Master unit sends „Auto Program
Part 1" to the Slave unit. If set to „Slave 2", the Slave unit receives „Chase Part 2".
To start a Auto Program please proceed as follows:
1.Slave-Setting
• Select "Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Slave" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter-button to confirm.
2. Automatic Program Run
• Select "Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Sequence" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Master" or "Alone". The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.
• Press the Enter-button to confirm.
3. Program for Select Chase
• Select "Edit Chase" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Select Chase" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Chase Part 1", "Chase Part 2" or "Chase Part 3", and thus select which
Slave program is to be sent. Selection „Part 1" means, that the Slave unit runs the same program as the
master units.
• Press the Enter-button to confirm.
4. Program selection for Edit Program
• Select "Edit Chase" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit Chase" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired program. With this function you can edit specific scenes into a
specific program.
• Press the Enter-button to confirm.
5. Automatic Scene Recording
• Select "Edit Chase" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit scenes" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired scene numbers. You can program a maximum number of 250
scenes.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired value.
• Press the Enter-button to confirm.
49/52
00081163.DOC, Version 1.0