Futurelight DMH-32 Bedienungsanleitung Seite 45

Fixture ID
RDM
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when
the device is installed in a remote area.
RDM is integrated in DMX without influencing the connections. The RDM-data is transmitted via the standard
XLR-poles 1 and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be
operated in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not
influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
Reload Default
With this function you can restore the factory settings of the device. The different settings (marked in the
table) will be set back to the default values (shaded).
Program
Play
DMX Receive
With this function, you can set the device to the DMX mode.
Slave Receive
With this function, you can define the device as slave. You can choose one of three different Slave
programs. For further information see „Edit Chase".
Sequence
With this function, you can run the internal program. You can select the desired program under "Select
Chase". You can set the number of steps under "Edit Chase". You can edit the individual scenes under "Edit
Scenes". With this function, you can run the individual scenes either automatically, i.e. with the adjusted
Step-Time. The selection "Alone" means Stand Alone-mode and "Master" that the device is defined as
master.
Music
With this function, you can run the internal program sound-controlled. The selection "Alone" means Stand
Alone-mode and "Master" that the device is defined as master.
Select chase for auto program
With this function, you can select the program for the Program Run.
Edit chase
With this function, you can edit the internal programs.
Edit scenes
With this function, you can edit the scenes of the internal programs.
Rec. Controller
The device features an integrated DMX-recorder by which you can transmit the programmed scenes from
your DMX-controller to the device. Adjust the desired scene numbers by pressing Up or Down (from – to).
When you call up the scenes at your controller, they will automatically be transmitted to the device.
45/50 00076667.DOC, Version 1.0