Electrical Interconnection - Hifonics X4-Atlas Bedienungsanleitung

Soundsystem

Inhaltsverzeichnis

Verfügbare Sprachen

INSTALLATION INSTRUCTIONS

BEFORE THE CONNECTION

For the professional installation of a sound system appropriate wiring kits are available in car audio retailer stores. Attend the sufficient

profile section (at least 35 mm

), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and

remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are

fixed tight after the installation, because loosely connections may cause malfunctions, unsufficient power supply or interferences.

FUSE

The inserted fuses protect the amplifier from shorts and capacity overload. Replace damaged fuses only with equal fuses with

the same fuserating (check the chapter Specifications).

NOTE: The integrated fuses are suitable for an 2 ohm amplifier operation. If necessary you have to advance the fuse rating for

an 1 ohm amplifier operation.

REM

Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your headunit with the REM-terminal of the

amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm

with your headunit.

BATT+12V

Connect the BATT+12V-terminal with the +12V pole of the vehicle's battery. Use therefor a suitable cable with a sufficient cross

section and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery must be shorter

than 30 cm. Do not install the fuse into the fuseblock until the installation is accomplished.

GND

Connect this GROUND terminal with a suitable contact ground point on the vehicle's chassis. The ground wire must be as short

as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground point has a stable

and safe electric connection to the negative "–"pole of the battery. Check this ground wire from the battery to the ground point if

possible and enforce it, if required. Use a ground wire with a sufficient cross section and the same size like the plus (+12V) power

supply wire.

PROTECT BRIDGE

If you would like to operate two similar amplifiers in the MASTER/SLAVE mode, connect both amplifiers with the appropriate

enclosed cable on the PROTECT BRIDGE port of each amplifier. This connection ensures in case of a malfunction or a defect

on one of the amplifiers (Master or Slave), that both amplifiers will run into the protection mode and shut down.

LOGO BADGE

With this switch you can choose between white or blue illumination of the upper logo badge.

Always follow the guidelines of your national road traffic regulations.

REFERENCE NOTE

Installation of RCA/Audio signal cables and power supply.

Please ensure while installation not to lead the audio cables between the headunit and the amplifier together

with the power supply wires on the same side of the vehicle. The best is a areal separated installation in

the left and right cable channel of the vehicle. Therewith a overlap of interferences on the audio signal will

be avoided. This stands also for the equipped bass-remote wire, which should be installed not together

with the power supply wires, but rather with the audio signal cables.