JVC DT-V9L5 Bedienungsanleitung Seite 19

Scope Setting*
1
Configure the settings for the wave form monitor and vector scope.
Item To do
Gain* 2 Adjust the input gain level.
Size* 3 Set the window size.
Position Select the window position.
Transparent Activates/deactivates the function to make the window translucent.
Off
On
Auto Off Set the function to turn off the window automatically 15 minutes after displayed.
Histogram Display Select the signal component for the histogram display.
Wave Display Select a wave form to be displayed for the wave form monitor.
Wave Filter Turn on/off the lowpass filter to put over the input wave form data.
Wave Over Level Marking Turn on/off the function to change the wave form color of signals over the value
specified in "Wave Over Level". (☞ below)
Wave Over Level Adjust the lower limit for the over level.
Example of the histogram display
Example of the wave form monitor
Ex.: When the luminance signal is Y, "Wave Over Level Marking" is set to "On" and
• The wave form color of signals over the value specified in "Wave Over Level"
turns red.
• The display differs depending on the input signal or the "Wave Display" setting.
* 1 The vector scope is not displayed when the input signals are RGB.
* 2 Unavailabe for the histogram.
* 3 Only "Normal" is available for the histogram.
: Normal
Translucent
:
"Wave Over Level" is set to "80"
Red
Y
Image signals
Start
White
End
Setting value
–10 to +10
Normal, Large
Lower Right, Lower Left
Upper Left, Upper Right
Off
On
Off, On
Y, R, G, B
Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
Flat (No filter)
Lowpass
Off, On
70 – 109
Example of the vector scope
Ex.: When the color bar is
displayed
17
EN EN