Maintenance; Moisture Condensation - JVC KD-BT1 Bedienungsanleitung

Setting menu
( : Initial)
Auto Connect
When the unit is turned on, the connection is
established automatically with....
Off: No Bluetooth device.
Last: The last connected Bluetooth device.
Order: The available registered Bluetooth device
found at first.
Auto Answer
Only for the device being connected for "Bluetooth
Phone."
Off: The unit does not answer the calls
automatically. Answer the calls manually.
On: The unit answers the incoming calls
automatically.
Reject: The unit rejects all incoming calls.
Message Info
Only for the device being connected for "Bluetooth
Phone."
Auto: The unit informs you of the arrival of a
message by ringing and displaying "MSG."
Manual: The unit does not inform you of the arrival of
a message.
MIC setting
Only for the device being connected for "Bluetooth
Phone."
Adjust the microphone volume, [Level 01/02/03].
Version
The Bluetooth software and hardware versions are
shown.

Maintenance

How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
Connector

Moisture condensation

Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
How to handle discs
When removing a disc from its
case, press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges.
Do not touch its recording surface.
When storing a disc into its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.
SETTINGS & REFERENCES
Center holder
Continued on the next page
41