Output Signals When The Viewfinder Is Connected; Connecting To Remote Control Unit Rm-P210; Connection - JVC KA-HD250 Bedienungsanleitung

PREPARATIONS
Output signals when the viewfinder
is connected
VF OUTPUT signals and displays are as shown below.
VF-P400
↓
Y
Termi- RGB
(Round
nal (BNC×3)
20p)
Signal RGB Y
GY-
HD250
VF RGB Y
SIGNAL
item
HD
G
(HDV)
Signal
DV G
RE-
VERSE
G
Dis-
PIC-
play
*3
TURE
G
*4
(G: Available, ×: Not available)
*1
Characters from the GY-HD250 are displayed for Y/P
P terminal output signals. Therefore, use the HD/SD-
R
SDI terminal output signal for this line.
*2
Signal is only output to the Y terminal of the Y/P
minal.
*3
SKIN TONE display is not available.
*4
The following displays are not available.
• ZEBRA
• Skin Detail range
• Safety Zone
• Focus Assist
12
Y/P /P Y/P /P VBS
B R B R
(BNC×3) (BNC×3) (BNC×3)
HD H/SD
Com- Com- Com-
po- po- posite
nent nent
COM- COM- COM-
PO- PO- PO-
NENT NENT SITE
*1 *1
G G G G
G × G G
G G G G
× × × ×
Connecting to Remote
Control Unit RM-P210

Connection

Y
(BNC×1)
Switch off RM-P210 power supply before attempting the con-
nection.
1.
Connecting the RM-P210
Y
Connect this device's RM multi-pin connector and RM-
P210 using the 26 pin camera cable. Length of the cam-
era cable should not be longer than 100 m.
Y
*2
G
*2
G
G
×
/
B
/P ter-
B R
2.
Connecting the DT109
Connect the Headset DT109 plug to the [INTERCOM]
terminal to use an intercom headset.
MEMO
This device supports only DYNAMIC-type headset. CAR-
BON-type headphones cannot be connected.